Job Description
Our client in Connecticut seeks [2+] contract-to-possible full time / direct hire Mechanical Engineer - Electronics Packaging specialist(s)...
As a Mechanical Engineer- Electronics Packaging specialist, you will be responsible for developing portions of the lithography system and/or associated tooling related to the electronics infrastructure.
The position requires highly motivated, extremely organized and self-driven individuals.
· As a Mechanical Engineer- Electronics Packaging Specialist you will:
· Perform mechanical design and development associated with packaging electronic circuits including, assembly design, analysis, test, and manufacturing introduction support for both new and existing electronics design projects
· Understand and mitigate possible failure mechanisms associated with materials, interconnects, and environmental loads to develop a reliable design
· Communicate with a team of multi-disciplined engineers (Systems, Electrical, Mechanical, Manufacturing, New Product Logistics, and Product Information Management) for design and logistic release approval
· Investigate and edit product structures, generate CAD models, 2D/3D drawings and be responsible for the final technical data package
· Create, edit, review, and drive Engineering Changes to closure
· Self-Checking and Peer-Checking department designs and change notifications
Experience and Education
5 to 10 years of Mechanical design & logistics
BS Engineering with a major in any of the following:
Mechanical Engineering (with Electronics Packaging Experience preferred)
Industrial Engineering (taken under advisement based on work experience)
Qualifications
Ability to design and document all aspects of the electrical infrastructure including:
AC, DC, Main power distribution (panel boards, boxes and cabinets)
Interconnect cables, bundles and connectors (harnessing)
Electronic racks, cabinets, control consoles
Interfacing with printed circuit board designs
Modeling of flex and rigid PWB’s including volumes and critical part locations
Experience designing electronic enclosure assemblies
Experience in sheet metal design
Experience designing for manufacturability (DFM) and developing assembly work instructions for low to medium volume products
Experience with 3D solid modeling for design conceptualization and realization (preferred experience using NX)
Experience supporting design fit check during integration & testing of electrical & electronic systems at the module, sub-system & system level
Knowledgeable of industry codes and standards (i.e. NEC 70, NFPA 79, Machine Tool Standards)
Knowledge of FEA is a plus
Working knowledge of wiring diagrams and schematic diagrams
Working knowledge of design drafting best practices including geometric dimensioning
Perform dimensional and tolerance analysis as needed
Strong written and verbal communication skills required
Ability to write assembly, test procedures, test specifications and test reports
Software
3D CAD - NX preferred (currently using NX11), other 3D CAD programs acceptable
DMS - TeamCenter preferred (currently using TC10), other DMS programs acceptable
Master Data - SAP, other Master Data Management systems acceptable