Job Description :
Multiple positions: Please pick one you like/ Suitable the most

) Verification Engineers.
We need about 6 engineers for this skill sets. (QCOM replacement, MSFT, JellyFish and Project K
The successful candidate will be working on ASIC Verification including UVM/OVM methodology.
The candidate should have worked on large ASIC design verification including major block and full chip verification.
Desired Skills and Experience
BSEE + 8 years or MSEE + 5 years
Participated in at least 3 tape-outs using UVM/OVM methodology.
Must have experience developing test plan, test benches, writing test cases.
Must have the capacity to debug and root cause failures.
Familiarity with UPF or CPF low power flow would be a big plus.
Experience verifying PCIe and DDR3/4 is desirable.
Experience verifying SOCs with ARM/Tensilica and the likes is highly desirable
Good scripting skills in PERL/TCL and Makefiles
Proficient in System Verilog, C, and C++.
2) RTL Engineers.
We need about 2-3 engineers in RTL. Please send resumes to Rajesh, Miguel and me.
5-10 years of industry experience in the following areas:
ASIC frontend development.
Logic design, RTL coding, verification, synthesis, and timing closure.
Strong in Hardware description languages (Verilog, System Verilog and VHDL
Scripting/programming in C/C++, Tcl, Perl/Csh.
Must have background with CPU integration, AMBA like bus protocol,
Familiarity FrontEnd flow like CDC/LINT
Must be Familiar with Low power methodologies, UPF/CFG/Powerartist.
AND



1. Senior Embedded Software Design Engineer
Job Description
· This is for embedded software for USB Video streaming from ARM SoC to a Linux Host
· Successful candidate has experience developing drivers and software for audio Video systems.
· Candidate must be expert in real-time software development for ARM processors. Fluent in Python, C, C++ is a must. Deep familiarity with layer 2 and layer 3 IPv4 and IPv6 is also desirable.
· Experience with Video algorithms and architectures is desirable but not mandatory.
· MSEE, MSCE, or comparable STEM degree required.
· This is a great opportunity to work with a great team on once-in- lifetime project.
· Will be responsible for firmware and Driver development for MIPI interface and USB Video streaming.


Requirements
· BSEE or equivalent STEM subject, required; MS is desirable.
· 5 years or more relevant experience (post BS work counts as experience)

Other Requirements
· Great communicator, written and verbal. Professional and pleasant to




2. Senior Embedded Software Design Engineer Consultant
Job Description
o This is a very high-visibility position designing embedded software for
an highly-advanced and very visible airborne communication system
for wireless internet distribution.
o Successful candidate has extensive experience developing drivers
and software for wireless systems such as Wifi, 802.11n, 802.11ac,
802.11ad, LTE or Wimax. Candidate must be expert in real-time
software development for ARM processors. Fluent in Python, C, C++ is
a must. Deep familiarity with layer 2 and layer 3 IPv4 and IPv6 is also
desirable.
o Experience with PHY layer link management, DSP, and RF calibration
algorithms and architectures is desirable but not mandatory.
o MSEE, MSCE, or comparable STEM degree required. Candidates with
strong math, RF, or physics background are highly encouraged to
apply.
o This is a great opportunity to work with a great team on once-in-
lifetime project.

Responsibilities (a la carte menu of opportunities)
o Driver and API development for Wireless 802.11ad modem
o Physical layer code software: RF calibration, Tx pre-emphasis, Rx de-
emphasis, phased array antenna beam steering, Tx power control and
Rx automatic gain control. Power-up DC offset and LO feedthrough
compensation and so forth.
o Link-layer management software: TDMA frame management, DAMA,
ARQ, Association, Acquisition, A-MPDU and A-MSDU management
o System power management: power load leveling and thermal
management. QoS modulation to constrain system power consumption
o Reliability: Watchdog managers, alarm management, shut down and
power up protocols for module activation/de-activation. SEU event
detection and protection.

Requirements
o BSEE or equivalent STEM subject, required; MS or PhD highly
desirable
o 5 years or more experience (post BS work counts as experience)
o Wireless experience (preferably 802.11ac or 802.11ad some high-
speed networking design experience also required

Other Requirements
o Great communicator, written and verbal. Professional and pleasant to


3. FPGA HW Engineer Consultant
Job Description
o This is a very high visibility position leading the design of Xilinx and
Altera FPGAs for a highly-advanced airborne wireless base station that
provides wireless internet from 60,000 feet.

Responsibilites
o Specify the design: Prepare FPGA Design Specification Word
document, including Requirements, Theory of Operation, Block
Diagram illustrating data, control, clock and power paths, and FPGA
test plan. Prepare Software Interface Control Document describing
programmable registers in Excel format (ICD)
o Architect and code in Verilog and/or System Verilog the FPGA design.
Prepare constraint files, instantiate IP blocks as needed
o Design test benches and run thorough functional simulations. Work
with software engineers to valid HAL-level software on the FPGA test
platform
o Work with board designers and software engineers to integrate FPGA
into the final hardware. Supervise final FPGA test.

Requirements
o Requires deep experience in FPGA design, from Specification, through
RTL, Synthesis, Place & Route, and Lab Test.
o Thorough fluency in Vivado and Quartus design environments.
o Experience with PCIe root complex IP. Experience with DSP design
(both processor and RTL-based) strongly desired.
Ethernet IP in Xilinx required. Experience with Zynq and Max 10 plus
components a plus.
o Experience design FPGA for high-reliability Wireless applications
strongly desired.
o Experience with design for DS-160 avionics standard strongly desired
but not required.
Qualifications
o BSEE required. MSEE, PhD desirable
o 5+ years relevant design experience

o Wireless experience (preferably 802.11ac or 802.11ad some high-
speed networking design experience highly desired
o Excellent diagnostic and troubleshooting skills, both software and
hardware
o Recent design experience with PCIe Gen2, Ethernet 1G
o Superb RTL design and synthesis skills for FPGA with Xilinx or Altera
o Great communicator, written and verbal
o Positive personality –great to work with

Client : qualcomm